INSTALLATION AND USER INSTRUCTION GUIDE Electric Fire With Remote Control Please read all instructions carefully and retain for future reference
Getting Started Remove appliance from the box. Remove any packaging from the product. Place packaging inside the box and either store or dispose of safely. In the box Fire body. Front panel. Concealed fixings pack containing: Screws and wall plugs Fixing bracket Remote control Instruction manual Features Remote control Dancing flame effect Detachable front Heater with two settings Thermal cutout Two heat settings - 750W and 1500W.
switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. Never immerse the product in water or any other liquid for any reasons. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. Do not use the appliance outdoors. Do not use if you have wet hands. Never use the appliance on or near hot surfaces. Do not operate with a damaged cord.
Helpful Advice Before Fitting Please retain all packaging until you have checked and counted all the parts and the contents of the fixing pack against the parts list. The fixing pack contains small items, which should be kept away from young children. We suggest that you open the fixing pack and place all the contents into a container, therefore reducing the risk of losing any small pieces. Installation The fire must not be used until it is securely fastened to the wall.
Manual Operation This is done by operating the switches located at the top right hand side of the fire .The standby rocker switch must first be switched on, the fire will beep to indicate that it is powered up. Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the dimmer mode, hold the button down until the desired brightness is obtained.
order to replace the lamps. Gently slide the front panel towards the top of the fire and remove. Store safely out of the way whilst the bulb is replaced so that it does not get damaged. At the bottom of the fire there is a lamp cover fixed by five Phillip's head screws, remove the screws and lift off the lamp cover-see Fig.5. For access to the bulbs, carefully slide the flexible rotisserie to one side ensuring that the rubber grommet is not lost-see Fig.6.
