Service manual

Easy Travel – Service Manual Rev. 0401 9
3.3 Controller Cover ET1B
Kit Number E0-00-1-034
Kit Number E0-00-1-705 (for serial # start-
ing with 11B)
Tools:
Phillips #2 Screwdriver
1. Remove Screws (8-A) at the top and
bottom of the Controller Cover (8-B) and
remove Cover
2. Disconnect Connector (8-C) from Inter-
face Circuit Board (8-D)
3. Check that the solder tabs of the Free-
wheel Switch on new Cover are bent
apart
4. Insert Connector of new Cover (8-C) to
Interface Circuit Board
5. Secure the Cover on the Column
NOTE: Ensure that the Power Cable is
routed under the Controller (see Figure
10) and that it will not be pinched when
closing and securing the Cover
6. Check drive, brake and freewheel op-
eration
Figure 8