Service manual

Easy Travel – Service Manual Rev. 0401 45
3.36 Domed Caps (Seat Supports)
Kit Number E0-00-1-075
Tools:
Screwdriver and/or
Pliers
Soft Mallet
1. Cover the flat tip of a screwdriver with
masking tape or electrical tape to pre-
vent paint damage
2. Remove the old Cap (45-A)
3. Tap the Cap (45-A) gently into the Tube
end (45-B) using a mallet
NOTE: Sharp blows will deform the Cap
3.37 Rear Frame Paint Protector Clips
Kit number E0-00-1-071
Tools:
Screwdriver
Soft Mallet
1. Cover the flat tip of a screwdriver with
masking tape or electrical tape to pre-
vent paint damage
2. Remove the old clip (46-A) from the
Tube (46-B)
3. Align the new Clip’s slotted stud (46-A)
with the hole in the Tube (46-B). Tap it
into place using a mallet or by squeez-
ing with your fingers.
Figure 45
Figure 46