Portable Oil Free Silent Series Compressor Operating Instructions NOTICE Carefully read this instruction manual before attempting to operate this compressor.
1-800-551-2406 www.eaglecompressor.
TABLE OF CONTENTS 4 Safety Precautions Cautions ……………………………………………… Extension Cords …………………………………….. Air Receiver …………………………………………. Safety Valve………………………………………….. 4 4 4 5 Installation and Operating Instructions …………………… Installation ……………………………………………. Break-In Procedure …………………………………. Before Operating the Air Compressor ……………… Maintenance ………………………………………….
SAFETY PRECAUTIONS Please familiarize yourself with the following information to prevent damage to your compressor unit and injury to the operator. The air compressor motor and/or engine will get hot while in operation. Never touch the discharge tubing, motor, or compressor pump while in operation. The compressor operates automatically while the power is connected and turned on, or the motor is running. Compressed air from the unit may contain hazardous fumes.
NEVER WELD, DRILL, OR CHANGE THE AIR RECEIVER IN ANY WAY. Any replacement parts should be purchased with the same specifications as the original equipment. Please contact the authorized dealer for replacement parts or specifications. SAFETY VALVE This valve is factory installed to prevent over pressurizing of the air receiver. It is factory set at a specific limit for your particular model, and should never be tampered with. Adjustment by user will automatically void the warranty.
INSTALLATION (cont..) 5. MAINTENANCE Before doing any maintenance or adjustments to your air compressor, the following safety precautions should be taken: * TURN OFF AND UNPLUG POWER CORD * DRAIN AIR RECEIVER AND AIR LINES OF AIR PRESSURE OPERATING YOUR AIR COMPRESSOR A) ELECTRIC DRIVE 1) 2) 3) 4) Check unit for any damage. Pressure switch "Off/Auto" switch should be in "Off" position. Plug in power cord to proper electrical outlet.
COMPRESSOR MAINTENANCE SCHEDULE DAILY OR BEFORE EACH USE Drain condensation from air receiver Check for any unusual noise or vibration Be sure all nuts and bolts are tight WEEKLY Turn off power. Clean dust and foreign matter from cylinder head, motor, fan blades, intercooler and air receiver. Clean air filter by opening air filter, removing filter element and cleaning it thoroughly. Worn or dirty filters should be replaced. MONTHLY Inspect unit for leaks. Tighten joints if leaks are observed.
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Will not start Check power supply Low pressure Safety valve leaks Drain cock open Loose tubes or fittings Dirty or plugged air filter Clogged inlet filter Dirty compressor, head, cylinder, intercooler Operating pressure too high Compressor cycle too long. Proper cycle is 50-60% on Stop/ Start operation.
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Motor stalls Replace unloader check valve Install valves correctly Tighten components Reduce operating pressure Loosen leg bolts Excessive Vibration Compressor Knocks Faulty unloader / check valve Valves incorrectly installed Loose compressor, motor Excessive discharge pressure Leg bolts tightened too tightly to floor Worn rods, wrist pin or main bearings Compressor valves loose or broken Inspect check valve, it may knock at low pressures Che
Page 10
NOTES 1-800-551-2406 www.eaglecompressor.