User Manual
Table Of Contents
- Specifications
- Introduction
- Using the Manual
- Trim Scheme
- Contents of Kit/Parts Layout
- Required Tools and Adhesives
- Required Radio Equipment
- Notes Regarding Servos and ESC
- Important Information About Motor Selection
- Lightweight Sport Setup
- Optional Accessories
- Recommended High Power Precision Aerobatic Setup
- Alternative Sport andPrecision Setups
- Optional Accessories
- Notes on Lithium Polymer Batteries
- Warning
- Warranty Period
- Limited Warranty
- Damage Limits
- Safety Precautions
- Questions, Assistance, and Repairs
- Inspection or Repairs
- Warranty Inspection and Repairs
- Non-Warranty Repairs
- Safety, Precautions, and Warnings
- Instructions for Disposal of WEEE by Users in the European Union
- Landing Gear Installation
- Motor Installation
- Aileron Installation
- Wing Installation
- Stabilizer and Elevator
- Rudder and Fin
- Rudder and Elevator Servos
- Control Throws
- Center of Gravity
- Range Test Your Radio
- Preflight
- Flying Your Eratix 3D 25e
- 2007 Official AMA National Model Aircraft Safety Code
9E-flite Eratix 3D 25e ARF Assembly Manual
Landing Gear Installation
Required Parts
• Fuselage
• Main landing gear
• Wheel pant (left & right)
• 2
3
/
4
-inch (70mm) wheel (2)
• 4-40 x 1/2-inch socket head screw (2)
• #4 washers (6)
• 4mm locknut (4)
• 4mm x 35mm machine screw (2)
• 2mm x 8mm wood screws (4)
Required Tools and Adhesives
• Phillips screwdriver (small)
• Needle-nose pliers
• Nut driver: 7mm
• Hex wrench:
3
/
32
-inch
1. Place the landing gear onto the bottom of the fuselage.
Attach with two 4-40 x 1/2-inch socket head screws and
two #4 washers.