User Manual
Table Of Contents
- Specifications
- Introduction
- Using the Manual
- Trim Scheme
- Contents of Kit/Parts Layout
- Required Tools and Adhesives
- Required Radio Equipment
- Notes Regarding Servos and ESC
- Important Information About Motor Selection
- Lightweight Sport Setup
- Optional Accessories
- Recommended High Power Precision Aerobatic Setup
- Alternative Sport andPrecision Setups
- Optional Accessories
- Notes on Lithium Polymer Batteries
- Warning
- Warranty Period
- Limited Warranty
- Damage Limits
- Safety Precautions
- Questions, Assistance, and Repairs
- Inspection or Repairs
- Warranty Inspection and Repairs
- Non-Warranty Repairs
- Safety, Precautions, and Warnings
- Instructions for Disposal of WEEE by Users in the European Union
- Landing Gear Installation
- Motor Installation
- Aileron Installation
- Wing Installation
- Stabilizer and Elevator
- Rudder and Fin
- Rudder and Elevator Servos
- Control Throws
- Center of Gravity
- Range Test Your Radio
- Preflight
- Flying Your Eratix 3D 25e
- 2007 Official AMA National Model Aircraft Safety Code
10 E-flite Eratix 3D 25e ARF Assembly Manual
2. Slide the 4mm x 35mm machine screw through one of
the
2
3
/
4
-inch wheels. Secure a 4mm lock nut against the
wheel. Make sure the wheel still spins freely.
3. Attach the wheel to the landing gear using a
4mm washer and a 4mm lock nut. Leave the nut
loose at this time.
4. Slide the wheel pant over the wheel. The 4mm washer
will be inside the wheel pant. Use two 2mm x 8mm sheet
metal screws threaded into the pre-drilled holes to attach
the wheel pant to the landing gear. Tighten the 4mm lock
nut using a 7mm nut driver to complete the assembly.
5. Repeat Steps 2 through 4 for the remaining wheel
and wheel pant.