User Manual

Post Flight

NOTICE: When you are ﬁ nished ﬂ ying, never keep the aircraft in the sun. Do not

store the aircraft in a hot, enclosed area such as a car. Doing so can damage the

foam.

Post Flight Checklist

1. Turn off ESC switch

2. Power off transmitter

3. Remove ﬂ ight battery from aircraft

4. Recharge ﬂ ight battery

5. Repair or replace all damaged parts

6. Store ﬂ ight battery apart from aircraft and monitor the battery

charge

7. Make note of ﬂ ight conditions and ﬂ ight plan results, planning for

future ﬂ ights

Service and Repairs

NOTICE: After any impact or replacement, always ensure the receiver is secure

in the fuselage. If you replace the receiver, install the new receiver in the

same orientation and manner as the original receiver or damage may result.

Thanks to the Z-Foam™ material in the wing and fuselage of this aircraft,

repairs to the foam can be made using virtually any adhesive (hot glue, regular

CA (cyanoacrylate adhesive), epoxy, etc). However, use only foam-compatible

CA, foam-compatible accelerant or epoxy on the vertical and horizontal tail

material.

When parts are not repairable, see the Replacement Parts List for ordering by

item number. For a listing of all replacement and optional parts, refer to the list

at the back of this manual.