User Manual

Model Assembly Continued

Wing Installation Continued

Wing Placement

1. Remove the canopy hatch from the fuselage by pulling back the release

button (aa), then pull up on the back of the canopy.

2. Turn over the fuselage so the bottom faces up and feed the servo wires

through the hole in the fuselage (bb).

3. Align the wing with the recess of the fuselage and fit the wing to the

fuselage.

CAUTION: DO NOT crush or otherwise damage the wiring when attach-

ing the wing to the fuselage.

4. Secure the wing in place using 4 screws (cc) (from bag D).

5. Turn the aircraft over to access the receiver and connect the servo

connectors as follows. All servo connections should be labeled.

• Connect the aileron and ﬂ ap servo leads as shown using the included

Y-harness (from bag F).

• Connect the main landing gear to the two open leads of the pre in-

stalled three-way Y-harness.

6. Reinstall the canopy hatch.

When needed, disassemble in reverse order.

Flaps

Ailerons

Gear