User Manual

Installation

1. Slide the wing tube (A) into the fuselage.

2. Install the left and right wing (B and C) over the wing tube and into the

wing slot of the fuselage.

3. Connect the servo connectors (D) to the respective connectors on the

fuselage (connectors are marked AIL or FLAP).

NOTICE: Always put excess servo connector wire into the pocket of the wing to

prevent pinching of wires or other damage.

4. Secure the wings on the fuselage using 2 long screws (E) in the front

holes and 2 shorter screws (F) in the rear holes in the top of the wings.

5. Install the 2 wing struts on the fuselage mount (G) using 2 pins (H) and 2

R-clips (I).

Removal

We recommend removing the wings from the fuselage for storage or transport

of the aircraft.

TIP: Remove the vertical bracket pins and clips from the struts to

pivot the brackets and struts down to the wings. Wing struts do not

need to be disassembled to be removed.

NOTICE: Always secure loose parts after removal. DO NOT FLY if parts are

missing or damage may result.

Wing Installation continued

AILE

FLAP

AILE

FLAP