User Manual

Horizontal Tail Installation

1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the

control horn faces down.

3. Install 4 screws (B) in the front and rear holes in the bottom of the

horizontal tail.

4. Attach the ball link (C) to the elevator control horn’s outermost hole using

the included nut (D) and screw (E).

5. Ensure the elevator servo arm is in the correct position, then adjust the

linkage to center the elevator.

When needed, disassemble in reverse order.

Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or

install a link on a control horn.