User Manual

Model Assembly

Horizontal Stabilizer Installation

1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the

control horn faces down.

3. Secure the 2 piece horizontal tail in place with 2 screws (M3 x 10mm) (B)

included.

4. Attach the ball link (C) to the elevator control horn’s outermost hole using

the included (M2 x 8mm) screw. Use a 2mm hex wrench to tighten the nut

and screw.

5. Ensure the elevator and rudder servo arms are in the correct position, then

adjust the linkage to center them.

Disassemble in reverse order.

M2 X 8mm

M3 x 10mm

Countersunk Machine Screw

Screw Chart

Location Size Screw Quantity

Elevator ball link screw M2 x 8mm 1

Wing screw M3 x 32mm 4

Horizontal stabilizer screws M3 x 10mm 2

Spinner screw M3 x 32mm 1

Propeller screws M3 x 16mm 6

Tail wheel mount screws 2.0 x 8 4

Hands free servo plugs screws 2.0 x 8 8

Servo cover screws 2.0 x 8 8

Landing gear door cover screws

(inside)

2.0 x 12 16

Landing gear door cover screws

(outside)

2.0 x 6 2

Retract cover mount screws 2.0 x 8 4

Wheel axle hub screws 4.0 x 25 2

Retract motor mount screws 3.0 x 16 8

Wing plug screws 2.0 x 8 16

X Mount screws 3..0 x 16 4

Motor mount screws 4.0 x 10 4

Ball link clevis screws 2.0 x 8 6