Manual

43. STEREO RETURNS
The stereo returns are used to route stereo signals (e. g. of an additional external
mixer, FX unit, etc.) to the master output.
In case you want to connect a monaural device, please use only the L/MONO
return connector. The monaural signal is internally routed to both channels.
44. STEREO RETURN
Rotary control for level adjustment of the signals coming from the STEREO
RETURNS. The actually outputted level is also influenced by the setting of the
master faders.
45. RECORD SEND L/R
These RCA-type connectors carry the PRE FADER master L/R signal. The signal
is not affected by the setting of the master faders and therefore mostly used for
the connection of cassette decks, open reel tape decks or DAT recorders for
recording purposes. The nominal level of the outputs is –10dBV and matches the
professional industry standard as well as most home recording applications.
Nevertheless, you should use the input gain control of your recording device - as
far as it is provided.
CAUTION:
On most tape decks the incoming signal is directly carried through to
the outputs. In case you have connected the REC. SENDS and the 2TRACK
RETURNS and the PowerMate’s 2TRACK to MASTER control is set to anything
but its lowest setting, the recorded signal is included into the main mix again. The
difference in delay of the two signals is responsible for occurring drop-outs and
the general degradation of the sound. In the worst case, activating the RECORD
button on your tape deck could lead to very unpleasant feedback noise. To prevent
this from happening make sure that you always have the 2TRACK to MASTER
control and the AUX3 control adjusted to their lowest settings. The 2TRACK
RETURN signal will pass unobstructed.
46. 2TRACK RETURN L/R
Here you can connect a tape deck, a CD player, an open reel or an additional
mixer. The signal is post master fader and post STANDBY switch. providing you
with the possibility to play intermission music during performance breaks or check
the mix during the rehearsal, using the headphones. You just have to engage the
STANDBY switch to mute all channel signals at the main outputs and the monitor
bus.
47. 2TRACK to AUX3
The signal coming from the 2TRACK RETURNS is internally added to the AUX3
bus (monitor bus) and its level is set with 2TRACK to AUX3 rotary control. The
signal gets added to the bus pre 2TRACK to MASTER control.
48. 2TRACK to MASTER
This control is used to mix the 2TRACK signal to the main mix; post fader of the
master controls.
CAUTION: When adjusting the level of the device that is connected to the 2TRACK
RETURNS – CD player, tape deck, etc. – always begin with the 2TRACK to
MASTER control adjusted at its minimal setting. Otherwise, depending on the
quality of the connected sound source, the outputted volume can instantly “hit the
top”.
MASTER
44