Faucet Parts & Accessories You may need the following tools/materials Valve Hoses (included) Pliers Screw Driver Silicone 2 Wrench Plumbers Tape
Product Dimensions 3
Installation Instructions Diagram 1 <1.5” (38mm) <1.5” (38mm) Note: 1.25” (30mm) 2” (50mm) Your faucet is designed for a hole with a diameter of 1 1/4” (30mm) and a deck thickness of up to 2” (50mm). The soap dispenser hole should not be larger than 1 1/2”. Please shut off water valves before conducting faucet assembly. Diagram 2 1 2 3 Step 1: Unscrew the shank (1) from the faucet (if it is connected) and place it to the side, along with the gasket (2) and mounting nut (3).
Installation Instructions Diagram 3 1 2 Step 2: The short water line is HOT water, while the longer water line is COLD. Securely attach both HOT (1) and COLD (2) water hoses to the faucet. Diagram 4 2 1 3 4 Step 3: Re-install the shank (1) and base (2) and proceed to install the faucet through the deck mounting hole. Attach the gasket (3) and mounting nut (4) onto the shank. Be sure the large side of the mounting nut is facing up.
Installation Instructions Diagram 5 2 1 Step 4: After the faucet is properly positioned, thoroughly tighten the mounting nut to secure the faucet in place. At this point, attach the end of the pull out hose (1) to the line converter (2). Diagram 6 1 Screw 2 Step 5: Disassemble the weight with use of a Phillips screwdriver. Once the weight is separated, attach the weight (1) onto the pull out hose (2) at your desired location.
Installation Instructions Diagram 7 Step 6: During faucet installation, filings, chips, and other debris can fall into the plumbing pipes. This debris can damage the internal faucet surfaces which can cause leakage. Before turning on the water valves, make sure the faucet handle is in the open (On) position in order to thoroughly flush out debris. Diagram 8 Step 7: Connect both water hoses onto the respective water valves (we recommend using plumbers tape to prevent leakage). Turn on the water valves.
Installation Instructions Diagram 9 Step 8: After the water valves are turned on, let water filter through the faucet for 30 seconds. Evaluate all connections for leakage. After this process is complete, you may proceed to use your new faucet.
Soap Dispenser Installation Diagram 1 5 4 2 3 1 Step 1: Remove soap canister (1), gasket (2) and mounting nut (3) from the soap dispenser’s shank (4). Place the soap dispenser (5) into the deck opening. From underneath the sink deck, attach the Gasket and mounting nut onto the faucet shank. Before tightening and securing the mounting nut, make certain the soap dispenser is properly positioned.
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.