User guide

DVDO Quick

6x2 4K Ultra HD HDMI Switcher

4. The following occurs:

a. While updating the green light on Input 3 blinks.

b. If the update was successful, the green lights on Input 1 and 3 blink alternately; if the update failed

the amber light on Input 2 lights solid.

c. Quick

then resets and enters the active mode.

5. Check the information screen from the main menu to confirm the new firmware version. If the update

failed, use the procedure described in the Upgrading Firmware Using the Update Firmware Button

section.

If you choose to return to the factory default settings, or if instructed to do so as part of the particular

firmware version you are updating to, refer to the Resetting to Factory Default Settings on page 25.

Upgrading Firmware Using the Update Firmware Button

This is a fail-safe method that works even if the firmware becomes corrupted and you cannot load firmware

from the OSD.

1. Download the two firmware files from DVDO.com, place them on a USB flash drive, and insert the drive

into the USB slot on the back of Quick

2. Unplug the power cord and all sources from Quick

3. While pressing the Update Firmware button, plug in the power cord.

4. Continue to press the Update Firmware button until the green LED on port 3 lights solid, for about three

seconds.

5. Release the Update Firmware button.

6. If the update was successful, the green lights on Input 1 and 3 blink alternately; if it fails the amber light

on Input 2 lights solid. This process normally takes between five and ten seconds.

If you choose to return to also reset settings to the factory default settings, or if instructed to do so as part of

the particular firmware version you are updating to, refer to the Resetting to Factory Default Settings on

page 25.