User guide

DVDO Quick

6x2 4K Ultra HD HDMI Switcher

CEC Enable: If *checked, Quick

responds to CEC commands such as power on or off.

If unchecked, CEC commands are ignored.

Send Initiate ARC: Enables the Audio Return Channel from the TV to the main HDMI

output and sends a request to the TV to begin sending audio.

Send Terminate ARC: Disables the ARC function and sends a request to the TV to exit

ARC mode.

Load FW from USB: Loads new firmware from an inserted USB flash drive. See the

Updating Firmware section on page 23 for more information.

Factory Settings: Resets Quick

to factory default settings; refer to the Resetting to

Factory Default Settings on page 25.

EDID Mode: Allows setting a fixed EDID.

HDMI 6 Power: Allows non-MHL mobile devices to charge on port 6 and aids with

compatibility with older devices. When activated, this input always appears to be active

even if the connected source is off. This results in a blank InstaPrevue and PIP window

and the amber input LED is always on. This feature is *Off by default.

*Auto: When selected, Quick

automatically senses source and display capabilities. Use

this for best compatibility unless you have trouble with a specific device.

Custom: When checked, one of the two capability choices below can be selected. These

options activate a special mode where all capabilities of attached devices are ignored and

the selected ones are used instead. This feature is *Off by default.

1080P, PCM: Sends 1080p video and stereo PCM audio EDID capability information to all

sources regardless of their display capabilities.

1080P, HBR: Sends 1080p video and High Bit Rate (HD) Audio EDID capability

information to all sources regardless of their display capabilities.

When using a custom EDID, this selection overrides any choices in the output setup menu.