User`s manual

62
Resources Controlled by
Values Meaning
Manual
The table will show the below items: “Reset Configuration
Data, IRQ-3 assigned to, DMA-0 assigned to.” The user can
adjust the shown items as required.
Resources
Controlled
By
Auto
The table will not show the above items, and the system will
automatically assign the above setup.
Resources
If you set the Resources Controlled by item to Auto (ESCD), the BIOS will manage all
resources for you. If you set it to manual to two items below will allow you to assign the
resources manually.
Values Meaning
PCI/ISA
PnP
This setting means the BIOS will assign the interrupt as needed.
This means that it is not fixed to a device
IRQ-x
assigned to
(x = 3 to 15)
Legacy ISA
If you need to make sure that a certain interrupt is assigned to
an ISA device, set that interrupt to legacy ISA.
PCI/ISA
PnP
This setting means the BIOS will assign the DMA Channel as
needed, it is not fixed to a device
DMA-x
assigned to
(x = 0, 1, 3,
5, 6, 7)
Legacy ISA
If you need to make sure that a certain DMA channel is
assigned to an ISA device, set that channel to legacy ISA.
PCI / VGA Palette Snoop
Values Meaning
Disabled Default setting.
PCI / VGA
Palette
Snoop
Enabled
This will allow the system to look at the palette the VGA uses
to display. Some applications speed up with this setting but it is
mostly obsolete.
Assign IRQs
Values Meaning
Enabled
This will assign an interrupt to your VGA card. Make sure to
enable this item if your card needs one.
Assign IRQ
for VGA
Disabled The BIOS will not assign an interrupt to the VGA card.
Enabled
If you plan to make use of USB devices, set this item to
enabled.
Assign IRQ
for USB
Disabled The BISO will not assign an interrupt to USB.