Installation Guide

www.dural.com
DURAL GmbH
Südring 11
D-56412 Ruppach-Goldhausen
Tel. [phone]
Fax [phone]
[e-mail]
EXP
07/2016
Since the usage and nishing of the product is not under our control, we accept no liability for the success of the work and can therefore only guarantee the nature of our products as per the accompanying product data sheets and in accordance with our general terms and conditions of sale. The properties listed here represent no guarantee with respect to the eventual use of our products. We reserve the right to make changes due to technical advances. Any other technical information given in the course of a consultation must be conrmed in writing. Colours shown here are restricted by the printing techniques and may differ from those exhibited by the products themselves. We also reserve the right to make alterations to the product technology or design. Only the current version of this data sheet is valid. Such versions are accessible by anyone via the internet. The issue of the latest data sheet invalidates all those that have been published beforehand.
Composite waterproof mat for walls and
oors in indoor areas
- Installation Instructions -
DURABASE WP 1/2
GENERAL:
Please refer to our DURABASE WP Product Information leaet. You can view this leaet online
at www.dural.com.
The generally recognised rules of good engineering practice must always be observed!
The following applies to all products/materials: suitability with respect to mechanical and che-
mical stresses must be checked carefully prior to installation of the mats.
Protect the material from long periods of exposure to sunlight.
DURABASE WP has been tested as a sealing material for use in conjunction with tiled and slab
ooring for the waterproong of buildings against non-pressing water under high stress,
e.g. wet rooms in public and private buildings. Information on suitable system components
is available on request.
INSTALLATION INSTRUCTIONS:
1. The oor making up the suboor must be dry and free of any material that would impair
adhesion. It must be level, able to bear weight and free from cracks. Any repairs must
be carried out prior to the installation of DURABASE WP. The installation subsurfaces can
be pretreated with a suitable primer as required. For cements screeds, a residual moisture
level of less than 2 wt % is applicable, and for calcium sulphate screeds, less than 0.5 wt %.
In addition, the regulations of the ZDB (German Construction Industry) Information Sheet
„Composite Seals“ apply to substructures and suboors.
2. Use a 4 x 4 mm serrated trowel to apply the thin-bed or exible mortar to the subsurface.
The adhesive should be chosen according to the subsurface type. The adhesive must bond and
mechanically join to the carrier fabric of the DURABASE WP matting. With most subsurfaces,
it is possible to use a hydraulic-setting exible mortar, or a fast-setting exible adhesive in
accordance with DIN EN 12004 / C2.