Installation Guide

ManualsBrandsDURAL ManualsBathTI-SHELF DRG 10.83 in. W Triangle-Shaped Corner Shower Shelf

www.dural.com

DURAL GmbH

Südring 11

D-56412 Ruppach-Goldhausen

Tel. +49 (0) 2602/9261-0

Fax +49 (0) 2602/9261-50

info@dural.com

EXP

09/2017

GENERAL

For general information on the product, please refer to the product infor-

mation on TI-SHELF on-line at www.dural.de.

TILE-LAYING INSTRUCTIONS

The TI-SHELF shelves are installed during tile-laying by embedding the per-

forated flange in the tile cement.

1. Treat the base surface as is required for tile-laying.

2. Apply tile cement with notch spacing appropriate to the tile size and

begin tile-laying.

3. Apply the TI-SHELF to the upper edge of the lower tile and embed the

perforated flange into the tile cement.

4. Continue with the tile-laying. In the process, notch the next higher

tile in the area of the TI-SHELF shelf.

5. Cut the decorative insert and adhere using an adhesive incorporating

a gentle gradient away from the wall.

6. Seal the wall connection joints with silicon. Seal the joints on the

front edge using flex grout.

When using on non-tiled surfaces, the TI-SHELF shelves can be screwed to the base

surface and the edge can be plastered.

Tileable shelves from stainless steel for

shower, bath and living areas

- Tile-laying instructions -

TI-SHELF

1/2

Since the usage and nishing of the product is not under our control, we accept no liability for the success of the work and can therefore only guarantee the nature of our products as per the accompanying product data sheets and in accordance with our general terms and conditions of sale. The properties listed here represent no guarantee with respect to the eventual

use of our products. We reserve the right to make changes due to technical advances. Any other technical information given in the course of a consultation must be conrmed in writing. Colours shown here are restricted by the printing techniques and may differ from those exhibited by the products themselves. We also reserve the right to make alterations to the

product technology or design. Only the current version of this data sheet is valid. Such versions are accessible by anyone via the internet. The issue of the latest data sheet invalidates all those that have been published beforehand.

TI-SHELF BV

TI-SHELF DRG

TI-SHELF RE

TI-SHELF TZ

TI-SHELF DNG

TI-SHELF DRS

TI-SHELF DNS

TI-SHELF FE

Summary of content (2 pages)

PAGE 1
Since the usage and finishing of the product is not under our control, we accept no liability for the success of the work and can therefore only guarantee the nature of our products as per the accompanying product data sheets and in accordance with our general terms and conditions of sale. The properties listed here represent no guarantee with respect to the eventual use of our products. We reserve the right to make changes due to technical advances.
PAGE 2
TI-SHELF 2/2 Tileable shelves from stainless steel for shower, bath and living areas - Tile-laying instructions - The TS-DNG and TS-DNS models can also be installed after the tile is laid. To do so, carefully remove the grout without possibly damaging the compound seal. Generously fill the joint with silicon and set the TI-shelf as far as possible into the joint. Remove excess silicon.