Specifications

11.3 Advanced Print Techniques for Non-Textile Materials

 The DTG Kiosk™ can print on many different

materials. Explained below are some other special

printing techniques we use.

 To print on irregular surfaced print media, we

recommend multiple coating. Especially if the

material is water-repellent, apply at least three

layers of coatings.

Please Note: the DTG Kiosk™ can print gaps up to about

4mm. If the gap exceeds more than 4mm, the images will

become fuzzy.

 Set the media type to Archival Matte Paper or

Watercolor Papar-Rediant White.

 Click the Advanced button.

 In Advanced window, make sure Color Management

is set to Color Controls

 Set the Mode to Automatic

 Set the print resolution to Photo 720.

 Take off High Speed check and click on the Paper Config

 Printing

 Move the tray to the ejecting side by pushing the

“EJECT” button and place the printing media in

the printer tray based on the layout in your

graphics program.

 Check the height of the print media by using the

Height Clearance Guide.

 Put the jig on the both edges of the printer tray

and adjust the height of tray to maintain a gap

between the highest point of the printing media

and the guide of approximately 2mm.

Please Note:

If the Height Clearance Guide touches the media during this test, then the printer head will

also make contact with the media during the printing process, potentially causing irreparable

damage to the print head. Make sure that you adjust the printer tray so that the print media

is set below the guide, and therefore the printer head

 Push LOAD button.

 Send the print job from your graphics application to the printer.

These instructions are provided as a guide only. You may have to experiment with the

variables such as the undercoat and the print settings of media type, print resolution etc. to

find the right combination to suit the media that you are attempting to print.