MSDS
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: DESIGNER DRYLOK – ALL COLORS HMIS CODES: H F R P
PRODUCT CODE: 239 – 240 1 1 0
SECTION I – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: (800) 424-9300
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: (570) 344-1202
NAME OF PREPARER: R. BARAKO
DATE ISSUED: JANUARY 2010
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT
WATER 7732-18-5 NOT ESTAB NOT ESTAB NOT ESTAB 1.0 (68F) 20-25
*DIETHYLENE GLYCOL MONO-
METHYL ETHER 111-77-3 NOT ESTAB NOT ESTAB NOT ESTAB 0.1 (68F) <5
DIBENZOATE ESTER MIXTURE 27138-31-4 /
120-55-8 NOT ESTAB NOT ESTAB NOT ESTAB <1 (68F) <5
STYRENE ACRYLIC RESIN 25036-16-2 NOT ESTAB NOT ESTAB NOT ESTAB N/A 10-15
WOLLASTONITE 13983-17-0 NOT ESTAB 10 MG/M
3
NOT ESTAB N/A 10-15
DIPROPYLENE GLYCOL MONO-
BUTYL ETHER 29911-28-2 NOT ESTAB NOT ESTAB NOT ESTAB 0.06 (68F) <5
NEPHELINE SYENITE 37244-96-5 5 MG/M
3
NOT ESTAB NOT ESTAB N/A 10-15
ENCAPSULATED ACRYLIC –
COPOLYMER 25214-39-5 5 MG/M
3
NOT ESTAB NOT ESTAB N/A <5
ALUMINA TRIHYDRATE 21645-51-2 NOT ESTAB NOT ESTAB NOT ESTAB N/A 20-25
• Indicates toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: 212 F SPECIFIC GRAVITY (H20 =1) 1.06
VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER
COATING VOC: DOES NOT EXCEED MAXIMUM VOC 100 G/L (0.84 LB/GAL)
SOLUBILITY IN WATER: SOLUBLE
APPEARANCE AND ODOR: WHITE OR COLORS, PRODUCT SPECIFIC. TYPICAL AMINE ODOR
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: N/A METHOD USED: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: 1.7% UPPER: 22.0%
EXTINGUISHING MEDIA: NONE KNOWN
SPECIAL FIRE FIGHTING PROCEDURES: CONTAINERS MAY SWELL AND BURST DURING A FIRE DUE TO INTERNAL PRESSURE CAUSED BY
HEAT. THIS MAY CAUSE A SLIPPERY CONDITION ON FLOORS
UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A
SECTION V – REACTIVITY DATA
STABILITY: PRODUCT IS STABLE
CONDITIONS TO AVOID: TEMPERATURES BELOW 32 (F) FOR STORAGE. TEMPERATURES BELOW 50 (F) FOR APPLICATION
INCOMPATIBILITY (MATERIALS TO AVOID): N/A
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: N/A
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR