User guide

ManualsBrandsDreams ManualsFurnitureCambridge Double Bedstead

2. If you follow the instructions carefully the end result shoud be worth

the effort.

Before you

Start, here

is some

helpful advice

5. To ensure an easier assembly, we strongly advise that all fittings are

only finger tightened during initial assembly.

In the unlikely event that this product has missing or damaged parts,

please call 0844 292 0000 to obtain spares

7. Keep glue and fittings out of chidren's reach.

6. We recommend a periodic check on all fixing points to make sure they

remain fully tightened.

4. Assemble this produc

t on a carpet.

3. Do not discard any of the packaging until you have checked that yo

have all the parts and the pack of fittings.

1. We suggest you spend a short time reading through this leaflet and

then follow the simple step by step instructions.

Assembly Instructions

CAMBRIDGE BED

Minimum No.of people

recommended to assemble

this product :

Approx assembly time :

3/4

hour

Summary of content (6 pages)

PAGE 1
CAMBRIDGE BED Assembly Instructions Minimum No.of people recommended to assemble this product : Approx assembly time : 2 3/4 hour 1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. Before you Start, here 2. If you follow the instructions carefully the end result shoud be worth the effort. 3. Do not discard any of the packaging until you have checked that you have all the parts and the pack of fittings. 4.
PAGE 2
Component parts and fittings contained in the box PARTS 2 ( 1piece ) 1 ( 1piece ) 4 ( 1piece ) 3 ( 1piece ) FITTINGS C x 04pcs H D x 02pcs I E x 01pc J F x 08pcs G (M6x45) (M6x20) x 04pcs x 06pcs (4x35) x 06pcs x 04pcs Note : The following fittings will be found in the box which contains the Slat Frame, NOT with the rest of Assembly Kit K x 02pcs M x 01pc L x 08pcs
PAGE 3
ASSEMBLY Step 1 Connect Side Rails 2 and 4 to Footboard 3 with Screws F by using Allen key E. Note : E Do not fully tighten at this point F 2 3 4 Step 2 E F 1 2 4 3 Repeat the process outlined in step 1 with the Headboard 1.
PAGE 4
Identify the slat system you have purchased...
PAGE 5
Sprung Slat System Assembly Step 3 L K M K L Step 4 Adjust leg height to suit bed frame x8 D
PAGE 6
ASSEMBLY Step 5 D G C H FIXED WOOD SLAT ASSEMBLY Step 6 J I DREAMS SPRUNG SLAT SYSTEM Position the Slat Frame so that the holes in the Frame align with those in the Side Rails 2 and 4. Secure the Frame to the Side Rails by threading Bolt G though Washer C and through the holes in the frame and the Side Rails.