Installation Guide

UNIDOOR PLUS (STYLE I) manual Ver 1 Rev 5 09/2016
9
2. Please mark measurement lines on the wall and
threshold for the Glass Door and U-channel
according to the size of your model.
You will need to use the Product Width values
determined in step #1 in Size Table A.
Please Note that these dimensions are nominal
dimensions and not actual glass sizes.
NOTE: M and L dimensions are from the finished
wall to the outside of the U-channel as shown in
Fig. 1.
NOTE: The Unidoor hinge is factory set to over close 8°.
The following procedure is recommended to ensure
proper alignment of the panel glass and door.
3. Align the Door so that it is perpendicular to the wall and
parallel to the threshold. Measure across the bottom span of
the Door and threshold on the outside of shower and
determine an equal value.
Mark a line on the threshold base on the handle side to assist
with aligning the inline panel glass.
See Fig. 2 for details.
L
Door
Panel
Return Panel
L-1/16"
M
L
M
M =
+
Door
Panel
1/8"
L =
Return Panel
+
7/16"
Fig. 1
Size Table A
Size Table A
Value
inside
outside
outside
inside
Door
Fig. 2
2
1