Installation Guide

Preparation

NOTE: DO NOT install the handle onto the door glass until instructed to do so. DO NOT attempt to

lift the glass using the handle. This could result in damage to the glass and/or serious personal injury.

Always use an assistant or a professional grade glass suction cup when handling heavy glass.

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with your packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the needed parts are included in the package by checking off the components on

the “Detailed Diagram of Shower Door Components”. If the unit has been damaged, has a finishing

defect, or has missing parts, please contact our customer support department within 3 business days

of the delivery date. Please note that DreamLine

will not replace any damaged products or

missing parts free of charge after 3 business days or if the product has been installed. Feel free

to contact DreamLine

if you have any questions, and please provide an order number, job name or

other proof of purchase to help us identify your original order.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine

not responsible for code compliance standards for your project and will not accept any returns.

3. If this unit is going to be installed in a new construction, please install all of the required plumbing

and drainage before installing the shower. Use a competent and licensed (if required by local code)

plumber for all plumbing installation.

4. Please make sure that prior to beginning the installation, the surfaces are leveled and solid and will

be able to support the total weight of the unit. Also make sure the walls are at right angles. Irregular

installation surface level, radius corners or improper angle of side walls will result in serious problems

for your installation. Note that some adjustments and drilling will be necessary during the installation

process.

5. Please protect all primary surfaces of the product during installation. Never set the glass down

directly onto a tile floor. Leave corner protectors in place until it is necessary to remove them.

Always use a piece of wood or cardboard to protect the bottom edge and corners of the glass prior

to and during installation.

6. This unit must be installed upon a finished threshold and against finished walls.

7. The hinge panel glass for this model should not be adjusted more than 1/4” for

out-of-plumb within the U-channel. This model does NOT have any adjustment for overall width.

Verify that the model size ordered will fit the finished opening before begining installation.

8. This model requires that you drill into the threshold for proper installation.

9. It is recommended to install the hinge-side U-channel into a stud.

10. This model requires minimum 5/8” of flat threshold space for installation.

Professional installation recommended

UNIDOOR-X (STYLE M) manual Ver 2 11/2016