Installation Guide

Table Of Contents

“UNIDOOR (STYLE G)” Ver 1 Rev 6 09/2016

4. Slip the cut U-channel 2 (bottom profile) (29) and

U-channel 1 (wall profile) (09) onto the Stationary

glass (11) in the shown locations.

With the door open, place the Stationary glass on

the half wall ledge opposite of door. Adjust the

Stationary glass and U-channel 1 (wall profile)

against the wall to compensate for any out of plumb

conditions ensuring that the Stationary glass is level

vertically and U-channel 1 is flush with the wall.

NOTE: The exposed vertical glass edge must be

flush with the finished half wall’s door side face.

Mark the U-channel 2 (bottom profile) end

opposite of the wall at the exposed vertical glass

edge.

Remove the U-channel 2 (bottom profile). Leave

the U-channel 1 (wall profile) on the Stationary

glass. Set the Stationary glass aside.

Cut the U-channel 2 (bottom profile) at the mark.

Slip the U-channel 2 (bottom profile) back onto

the Stationary glass.

See Fig. 5 for details.

wall

inside

Stationary

glass

U-channel 2

U-channel 1

wall

inside

Fig. 5

H (+) 1"

Fig. 4