Installation Guide

17UNIDOOR-X Style M Ver 1 Rev 6 06/2016

Fig 14

For Style M only: If your model does not include additional

panel glass, procede to install the L-shaped strip (#08) to

the wall for the door to close against to seal.

13. With the door closed place the L-shaped strip (#08) on the door

edge and mark its location on the wall.

Please note that the corner of the L-shaped strip (#08) should face

inward.

With the door opened, remove the tape backing from the adhesive

strip and firmly press the L-shaped strip (#08) to the wall. Allow time

for the adhesive to set before allowing the door to close against the

L-shaped strip (#08).

See Fig. 14 for details

NOTE:

The above procedure for installing the L-shaped strip (#08) is for the

Unidoor Style M shower door only. If installing another model please

refer to the separate panel glass installation manual located in the

glass packaging for model specific instructions. Hinges set to over-

close require the use of the L-shaped strip (#08) or other strike vinyl.

ATTENTION:

Prior to the next step, please be sure that the section of the

wall where you need to attach the L-shaped strip (#08) is

clean, dry and free from soap, oil and any construction debris.

NOTE:

If the model included adjustable hinges, see page

#19 for the adjustable hinge instructions.