Installation Guide

16UNIDOOR-X Style M Ver 1 Rev 6 06/2016
Fig 12
Fig 13
2
3
4
1
Door
1”
1
2
3
4
5
6
7
8
Around Bottom sweep
measure
measure
Handle side of door
11. Measure the bottom of the Glass door (#01) from
end to end to determine the actual width of the door.
Cut the Bottom anti-water strip (#07) to the size of
your measurement and notch 3/8” of the inner side of
the Bottom anti-water strip (#07)as shown in Fig 12
Press the Bottom Anti-water strip (#07) onto the
bottom edge of the Glass door (#01).
NOTE: Make sure the Bottom anti-water strip (#07) is
flush to the vertical edge of the Handle side of the Glass
door (#01).
See Fig. 12 for details
12. To install the Flanged side strip (#33), take three measurements :
• from the top edge of the Glass door (#01) to the top of the center portion of the top Hinge (#06)
(see Fig 13.1 for an example to use for all three measurements)
• from the bottom of the center portion of the top Hinge to the top of the center portion of the
bottom Hinge (#05)
• from the bottom of the center portion of the bottom Hinge (#05) to the threshold
Cut the Flanged side strip (#33) according to these measurements.
Notch the cut strips to be able to slide them into the Hinges and around the installed Bottom anti-water
strip (#07) to cover the space between both glass panels.
Open the door and press the cut strips onto the vertical edge of the Glass door (#01) so that it will overlap
the panel glass. See Fig. 13 for details