Operation Manual

18
english
Bench assembly for compact pedestal version
At the head sides of the bench, plastic side panels have
already been fitted in the factory using "furniture screws".
These side panels must now be removed to continue
with the assembly. Remove the screws using a large
screwdriver or a normal coin.
Fig. 12
Push the foot panel with the projecting flaps
between the rear wall and head strut
Head strut
Rear wall
Fig. 7
Front pedestal cover panel
Fig. 6

®
¬
Shove it into the
grove until it snaps
Lightly press in here
Top edge of front
pedestal panel goes
into the groove
Secure the outer sides of the pedestal covers toward
the foot end. Again, make sure that the lightly grainy
surface on the panel is facing outward.
Take 3 ea. of the 4,2 mm x 9,5mm sheet metal screws
from the accessories bag and use them to secure the
panels.
Fig. 9
Fig. 8
Pedestal cover
Pedestal
cover
Front pedestal cover
panel
That is all you need to do, put the pedestal together. The
bench can now be situated onto the intended securing
points on the pedestal.
As prepration of mounting the canopy, loosen the top
securing screws on the side panels at both the right and
left sides. Use a big screwdriver to do this.
Fig. 10
Side cover
Top securing
screw
Mouthlike groove
Protection Plate
Securing screw to
Canopy Chassis
Fig. 11
After loosening the screws, pull the side panel out-
ward, then using a screwdriver, place it gently in the
gap to keep it ajar. See fig. 11.