Installation Instructions

5c. Additional Support: For best results
use panel nails in addition to adhesive to
secure woodgrain, brick and stone panels.
For PegPanels, use adhesive combined with
drywall screws for added strength.
5c. Soporte Adicional: Para mejores resultados use
clavos para paneles juntamente con el adhesivo para
asegurar paneles de madera, ladrillo o piedra. Para
Paneles de Clavija, use adhesivo en combinación con
tornillos para tablayeso para agregar fuerza.
AquaTile and Panelboard: Use high quality
solvent-based or Low-VOC (contains water)
trowel-grade tileboard or construction adhe-
sive. Can use 6-7 tubes of 10.5 oz. cartridge
adhesive per panel, if gallon trowel-grade is
not available, but once extruded onto panel,
must still be troweled out with appropriate
notched trowel. Follow manufacturer’s rec-
ommended safety instructions. Do not nail
AquaTiles or PanelBoards.
5d. Solvent-based adhesive application:
Use a 3/16" V-notched trowel held at a 45°
angle, and thoroughly cover panel back with
adhesive. Wait 5-10 minutes to allow adhesive
to flash off (but remain tacky), then firmly press
panel to wall.
Low-VOC adhesives (water-based)
application: Use 1/8" V-notched trowel at
45° angle, and thoroughly cover panel back,
out to edges, with adhesive. Wait 10 minutes
for adhesive to flash off (but remain tacky), then
firmly press to wall. Re-press panel every 15
minutes for the next hour, especially edges.
AquaTile y Panelboard: Use adhesivo de alta calidad
con “Base de Solvente” o “Bajo en COV” (contiene agua)
aplicable con llana para tablero de azulejo o construc-
5c
5d