User's Manual

Position the microphone properly by pulling or pushing the boom along the slide.
Switch between left and right ear wearing style simply by rotating the microphone boom. Hold on to the earhook while gently
turning the boom.
For the dual-ear versions, also rotate the two earhooks.
Adjust the microphone boom to follow the shape of your face by gently bending the soft steel on the cable hanger.
Adjust the angle of the cable run, also by gently bending the soft steel (see arrows). Position the cable as shown on the picture for
securing the position of the microphone.
The cable relief on the dual-ear version should be fixed in the clip that also holds the two wires on the mount.
Always leave the protection grid on the d:fine Omnidirectional and d:fine
TM
Directional, as it protects the inner grid and oers protec-
tion against wind and breathing noise. The protection grid is replaceable.
Service connector for exchange of cables or booms on the d:fine
TM
Omnidirectional, d:fine
TM
Direc-
tional, d:fine
TM
66 and d:fine
TM
88
These d:fine
TM
Headset Microphones oer exchange of cables or microphone booms. Simply locate the service ac-
cess point, pull back the small protection cap and gently pull the boom away from the cable hanger.
Windscreens
The enclosed windscreens oer additional protection against wind and pop noise. Gently draw the windscreen over
the microphone head.
For even better protection, bigger windscreens are available.
Sweat stop
The microphone is equipped with a transparent sweat stop around the microphone boom to prevent sweat running
along the microphone boom to the microphone head.
Accessories (see more at www.dpamicrophones.com)
Grids and windscreens, cables and adapters, booms and earhooks.