Owner's manual

1819-065-B-4-07
3.2 Phone Number programming
3.2.1 Programming 7-digit Phone Numbers
In this programming sequence, the directory code and 7-digit phone number will be programmed into
the system. To program phone numbers that will be referenced to an area code (long distance calls
and 10 digit calling), follow the instructions under Long Distance Phone Number Programming.
NOTE: If this telephone entry system is being used in an area that requires 10-digit dialing,
proceed to 3.2.2 and 3.2.3 to program the area code and phone number.
1. Press *01 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 001 then press * (beep).
3. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number that
you are entering in this step is less than seven-digits, enter # in the empty spaces. For
example, if the system is connected to a PBX that requires four-digit extension numbers
and you want to enter extension 2217, you would enter this number as 2217### then
press * (beep).
4. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.2 Programming Area Code
Use this programming sequence for any 10-digit or long distance calling requirement. The area code
will be entered as a four-digit number (1 + the three digit area code). If the area code is being
programmed to facilitate 10-digit calling requirements, precede the three-digit area code with #.
1. Press *24 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter a 2-digit area code reference number _ _ (01 through 15) then press * (beep).
3. Enter the area code _ _ _ _ then press * (beep). NOTE-1: for long distance calling
requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit calling
requirements, enter # and the three-digit area code.
4. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.3 Programming Phone Number with Area Code Reference
In this section, phone numbers that are referenced to an area code (long distance and 10-digit dialing
calls) will be programmed. Be sure that the area code(s) have been programmed as described in the
preceding section.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.2.1.
1. Press *41 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 001 then press * (beep).
3. Enter the 2 digit area code reference number _ _ then press * (beep).
4. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number
that you are entering in this step is less than seven-digits, enter # in the empty
spaces. For example, if the system is connected to a PBX that requires four-digit
extension numbers and you want to enter extension 2217, you would enter this
number as 2217### then press * (beep).
5. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 25