Manual

EN
Connecting the inverter MSI
10
• For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load can lead
to the automatic shut-off of the inverter.
• The installation surface must be level and sufficiently strong.
A
Fasten the inverter as follows:
➤ Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the holders.
7 Connecting the inverter
A
Make sure that a professional fuse is installed between the positive pole (+) and the
inverter. Mind the following values:
• MSI412: 40 A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts
of the vehicle can be damaged by drilling, sawing and filing.
NOTICE!
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
1.
2.
5
MSI412-IO-AU.book Seite 10 Donnerstag, 13. Oktober 2016 4:05 16