Use and Care Manual

s. Secure the vehicle. Be sure to set the brakes and place the vehicle in park.

t. Release the tension on the wire rope. The winch is not meant to hold the vehicle for

long periods of time.

u. Disconnect the wire rope from the anchor.

v. Rewind the wire rope. Make sure that any wire already on the drum has spooled

tightly and neatly. If not, draw out the wire and re-spool from the point where the rope

is tight.

w. Keep your hands clear of the winch drum and fairlead as the wire rope is being

drawn in.

x. Secure the hook and hook strap.

y. Disconnect the remote control and store in a clean, dry place.

z. Clean and inspect connections and mounting hardware for next winching operation.

MAINTENANCE

1. Periodically check the tightness of mounting bolts and electrical connections.

Remove all dirt or corrosion and always keep clean.

2. Do not attempt to disassemble the gear box. Repairs should be done by the

manufacturer or an authorized repair center.

3. The gear box has been lubricated using a high temperature lithium grease and is

sealed at the factory. No internal lubrication is required.

REPLACING THE WIRE ROPE

1. If the wire rope has become worn or is beginning to show signs of strands

breaking, it must be replaced before being used again. To do this, remove the

defective rope by free spooling. Remove the bolt (Part# 800008) M6x10 on the

drum and release the rope.

2. Insert the end of the new rope and secure the M6 x 10 mm bolt tightly.

3. Engage the clutch and re-spool the new rope on the drum keeping tension on the

rope as it spools. Ensure that the rope is respooling in the under wind position.

WARNING - Only replace the wire rope with the identical replacement

part recommended by the manufacturer.