Use and Care Manual

9
GENERAL TIPS FOR SAFE OPERATION
 The C8000 and its all derivative types are rated at 8000 lbs capacity
when spooling the first rope layer on the drum. Overloads can
damage the winch/motor/ or wire rope. For loads over 6800 lbs. we
recommend the use of the pulley block/snatch block to double the
wire rope line. The will aid in two ways: a) reduce the number or
rope layers on the drum, as well as, b) reduce the load on the wire
rope by as much as 50%. When doubling the line back to the
vehicle, attach to the frame or other load bearing part.
 The vehicle engine should be kept running during operation of the
winch to minimize battery drain and maximize power and speed of
the winch. If the winch is used for a considerable time with the
engine off the battery may be drained and too weak to restart the
engine
 Get to know your winch before you actually need to use it. We
recommend that you set up a few test runs to familiarize yourself
with rigging techniques, the sounds your winch makes under
various loads, the way the cable spools on the drum, etc.
 Inspect the wire rope and equipment before each use. A frayed or
damaged rope shall be replaced immediately. Use only
manufacturer’s identical replacement rope with the exact
specifications.
 Inspect the winch installation and bolts to ensure that all bolts are
tight before each operation.
 Never connect the cable back to itself. This will cause cable
damage. Always use a snatch block, sling or chain of suitable
strength as shown in the illustrations.
 Store the remote control inside your vehicle in a place that it will not
be damaged.
 Any winch that appears to be damaged in any way, is found to be
worn, or operates abnormally SHALL BE REMOVED FROM
SERVICE UNTIL REPAIRED. It is recommended that the
necessary repairs be made by a manufacturer’s authorized repair
facility.
 Pull only on areas of the vehicle as specified by the vehicle
manufacturer.
 Only attachments and/or adapters supplied by the manufacturer
shall be used.