Troubleshooting Guide

v.190915 En.11

ENGLISH

TROUBLESHOOTING

Plow is not funcƟoning:

1. ConĮrm the main power and control wire plugs are clean and properly connected

2. ConĮrm the control wire is properly connected to the hand held control.

3. ConĮrm that the main power inline breaker was not accidently tripped. Press the red buƩon on top

and push the trip wing back in to reset

Not the Įrst three…

4. Do a quick test of the hand held control, standing between the snowplow and the vehicle on the

passenger’s side unplug the grey control wire at the rubber plug assembly, leave the main power plug

connected, with the

use of needle noise pliers perform the two operĂƟons shown below on the plow

side of the plug. Try raising Įrst and the pump should run, then lower.

To raise the plow… To lower the plow…

A - If the plow operates there is an issue with the control or control wire, check the wire carefully to make sure

is not cut or pinched, remove and reconnect the wire from the boƩom of the hand held control, re-connect the

control wire to the plow and re-test.

PAGE 1
TROUBLESHOOTING ENGLISH Plow is not funcƟoning: 1. ConĮrm the main power and control wire plugs are clean and properly connected 2. ConĮrm the control wire is properly connected to the hand held control. 3. ConĮrm that the main power inline breaker was not accidently tripped. Press the red buƩon on top and push the trip wing back in to reset Not the Įrst three… 4.
PAGE 2
ENGLISH TROUBLESHOOTING B - If the plow did not operate during the jumper test, check the small 10amp in line fuse down by the pump motor. If the fuse is ok remove the pump guard and with the use of a voltage tester conĮƌŵ that there is 12volts on the main terminal where the red power lead is connected on the solenoid. If there is 12V supply try the next test to see if the control wire is defecƟve. Remove the cap on the main power feed and the green control wire from the solenoid.
PAGE 3
ADJUSTMENTS If you are leaving the snowplow aƩached to a vehicle make sure rocker switch is in the middle poƐŝƟon on your hand held control when parked. If it is lĞŌ ŝŶ the down (oƌ Ňoat mode) poƐŝƟon it will conƟŶue to consume power and eventually drain your baƩery Skid Shoe Adjustment With the use of two 1-1/8 open end wrenches loosen the jam nuts, adjust to desired height and reƟghten v.190915 En.