Operation Manual
©
2015 DJI. All Rights Reserved.
17
INSPIRE 1 PRO
User Manual
Aircraft automatically descends and lands if RTH is triggered when the aircraft ies within a 20
meter (65 feet) radius of the Home Point.
Aircraft cannot avoid obstruction during the Failsafe RTH, therefore it is important to set an
reasonable Failsafe altitude before each ight. Launch the DJI GO app and enter “Camera”
view and select “MODE” to set the Failsafe altitude.
Aircraft will stop ascending and immediately return to the Home Point if you move the throttle
stick if the aircraft reaches 20 m altitudes or beyond during Failsafe.
When the critical battery level warning activates and the aircraft is descending to land
automatically, you may push the throttle upward to hover the aircraft and navigate it to a more
appropriate location for landing.
Color zones and markers on the battery level indicator reect estimated remaining ight time
and are adjusted automatically, according to the aircraft’s current status.
Failsafe RTH
Failsafe RTH is activated automatically if remote controller signal (including video relay signal) is lost for
more than 3 seconds provided that Home Point has been successfully recorded and compass is working
normally. Return home process may be interrupted and the operator can regain control over the aircraft if
a remote controller signal is resumed.
Failsafe Illustration
GPS
Dynamic Home Point
Dynamic home point is useful in situations when you are in
motion and require a Home Point that is different from the
takeoff point. GPS module is located at the position shown in
the gure below:
Ensure the space above the GPS module is not
obstructed when using Dynamic Home Point.
5 Go Home(20m can be set)
Fast Blinking Yellow
1 Record Home Point (HP)
Blinking Green
3 Remote Controller Signal Lost
Fast Blinking Yellow
2 Conrm Home Point
Blinking Green
6 Landing after Hovering 15secs
Fast Blinking Yellow
4
Signal Lost Lasts 3secs.
Fast Blinking Yellow
Height over HP>20m
Elevate to 20m
Height over HP<=20m
20m