Installation Manual

INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS DTK-4LVLP-CR
MATERIAL:
DATE:
REVISED:
DRAWN BY:
APPROVED BY:
DWG NO.
FINISH:
8-23-01
TITLE:
PART NO.
REV.
RWM
DTK-4LVLP-CR
LOW VOLTAGE CARD READER CIRCUIT PROTECTION
NOTE: THIS DEVICE IS INTENDED FOR INDOOR USE ON ISOLATED LOOP CIRCUITS, DATA,
 OR LOW VOLTAGE TELECOMMUNICATION CIRCUITS.

1. BEFORE BEGINNING INSTALLATION, MAKE SURE THE POWER IS OFF.
2. THIS DEVICE MUST BE CONNECTED IN SERIES BETWEEN THE FIELD WIRING AND THE
EQUIPMENT TO BE PROTECTED.
3. SECURELY MOUNT THE BASE CLOSE TO THE CIRCUIT BEING PROTECTED USING THE
DOUBLE SIDED TAPE (SUPPLIED), OR TWO #8 SCREWS (NOT SUPPLIED).
4. MAKE SURE THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO PROTECTED
EQUIPMENT IS GREATER THAN THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO
GROUND.
5. USE ONE COMMON GROUND PER SYSTEM TO ELIMINATE THE POSSIBILITY OF A
DIFFERENCE IN GROUND POTENTIALS.
6. FOLLOW THE DIAGRAMS ON THE UNIT AND CONNECT THE WIRES ACCORDINGLY.
7. AFTER ALL CONNECTIONS HAVE BEEN MADE AND NO HAZARDS EXIST, RESTORE POWER.
8. IF YOU HAVE ANY QUESTIONS CALL TECHNICAL SUPPORT AT: 1-888-472-6100.
INT-100025-001
191405
2
SURGE PROTECTION
SLOT
0.180" x 0.240"
TYP. 2 places
3.00"
1.60"
1.165"
1.555"
0.10"
2.60"
0.20"
(1v)
LED AUD.
DATA (5V ) 5-12VPWR
24VPWR
INPUT UNPROTECTED
DTK-4LVLP-CR
}
}
}
SURGE PROTECTION
(1v)
LED AUD.
DATA (5V) 5-12VPWR
24VPWR
INPUT UNPROTECTED
DTK-4LVLP-CR
}
}
}
SURGE PROTECTION
(1v)
AUD. LED
DATA (5V)5-12VPWR
24VPWR
OUTPUT PROTECTED
DTK-4LVLP-CR
}
} }
SURGE PROTECTION
Diversified Technology Group, Inc.
1720 Starkey Road Largo, Florida 33771
Tel. [phone] Fax [phone]
6-5-02