Product Manual
12
Operating Instructions
Preparation for Operation
Fill Engine Crankcase with Oil
1. Add oil according to engine manual. Do not overll. Use a
clean, high quality detergent oil. Use no special additives with
recommended oils. Do not mix oil with gasoline. Oil level must
be full. Check the oil level by removing oil ll plug. Oil level
should be up to the bottom of the ll plug opening.
2. Always check oil level before starting engine. Refer to engine
manual for capacity and type of oil to use.
Pre-Start Inspection
1. Make sure safety shields are in place and nuts & bolts are secure.
2. Check oil level in engine crankcase. See your engine manual for
procedure and specications.
3. Inspect air cleaner for cleanliness.
4. Check the fuel supply. Fill the fuel tank no closer than 1 inch
from top of tank to provide space for expansion. See your engine
manual for fuel recommendations.
5. Be sure spark plug wire is attached and spark plug is tightened
securely.
6. Check position of wheels and wheel lock pins.
7. Check depth regulator lever position.
8. Examine underneath and around engine for oil or fuel leaks.
9. Inspect fuel hoses for tightness and fuel seepage.
10. Look for signs of engine damage.
11. Remove excessive debris from muer area and recoil starter.
WHEELS MUST ALWAYS BE LOCKED IN THE TILLING
POSITION WHEN ENGINE IS RUNNING.
Do not operate the tiller with the wheel lockouts unlocked. Always
set the wheels in tilling position before starting engine. Always put
the depth regulator lever in the transport position before starting
engine. Tines should clear the ground.
!
WARNING