Instructions / Assembly

10
Hose Connection
USE ONLY A NON-COLLAPSIBLE INTAKE HOSE
DO NOT OVER TIGHTEN HOSE CLAMPS
e suction hose must be reinforced or be constructed of
non-collapsible material. Do not use a hose with an inside
diameter smaller than the pump’s intake and discharge ports.
1. Slide a hose coupling ring over the hose coupler, then place
a gasket on the end of the hose coupler.
2. read the hose coupling ring onto the intake port, and
turn clockwise until fastened securely.
3. Slide a hose clamp over the end of the suction hose. Slide
the hose onto the hose coupler. Use a screwdriver to
tighten the hose clamp until secure.
4. Slide a hose clamp over the other end of the suction hose.
Slide the intake strainer into the end of the suction hose.
Use a screwdriver to tighten the hose clamp until secure.
!
CAUTION
SUCTION
HOSE
INTAKE
PORT
INTAKE
STRAINER
HOSE
CLAMP
GASKET
HOSE
COUPLER
HOSE
COUPLING
RING
DISCHARGE
PORT
DISCHARGE
HOSE
5. For the discharge hose, slide a hose coupling ring over the
hose coupler and place a gasket on the end of the hose
coupler.
6. read the hose coupling ring clockwise onto the discharge
port until tightened securely.
7. Slide a hose clamp over the end of the discharge hose.
Slide the discharge hose onto the hose coupler. Use a
screwdriver to tighten the hose clamp until secure.