Operating Guide

ManualsBrandsDimplex ManualsElectric Fireplaces28.5-in W Charcoal Oak Infrared Quartz Electric Fireplace

Operating Instructions

C3P23LJ-2085CO

7215980100R00

www.c3furnishings.com

! NOTE: The heater on

your fireplace may emit a

slight, harmless odor when

first used. This odor is a

normal condition caused

by initial heating of internal

heater parts and will not

occur again.

CUTOFF SWITCH

! NOTE: There is a safety

temperature cutoff switch

(cutout) inside the heater.

If the heater overheats,

the cutout will shut off the

supply power.

It can be reset by

unplugging the unit and

waiting 5 minutes before

plugging the unit back on.

CAUTION: If you need

to continuously reset the

heater, unplug the unit and

call technical service at

1-888-346-7539

Power ON/OFF

The ON/OFF button turns the fireplace ON and OFF. When the

fireplace is OFF, power indicator icon is lit red. Power icon turns

green when power is ON.

The fireplace has a built-in memory function, when turned back on,

it starts at the last used settings except for the timer. If the fireplace

insert is disconnected from the main power source, it reverts to the

default settings.

! NOTE:

Each time the fireplace insert is plugged in, it runs an internal

program check and the heater will turn on for 5 seconds.

The fireplace can be operated with the multi–function IR remote

control or from the control buttons located on the top-right corner of

the fireplace.

The remote control has an operating range of up to 5.8m / 19ft.

1. Power ON/OFF

2. Mode Button

3. Up/Down Buttons

4. Indicator Icons

5. Digital Display

Remote

154

Summary of content (2 pages)

PAGE 1
C3P23LJ-2085CO Operating Instructions ! NOTE: The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. The fireplace can be operated with the multi–function IR remote control or from the control buttons located on the top-right corner of the fireplace. The remote control has an operating range of up to 5.8m / 19ft.
PAGE 2
Flame Brightness Set Mode Mode Button Press the Mode Button to cycle through Heat, Timer or Flame Brightness set mode. Heat Set Mode When active press Up or Down Button to set temperature from 59°F (15°C) to 86°F (30°C), ON and OF. ‘ON’ means the heater operates continuously. ‘OF’ (OFF) means only the fan will operate the heater will be off. ! NOTE: When the heat is turned off, the heating element will shut down first then the fan after 20 seconds.