Owner`s manual

11
Fireplace Installation
wire from the power supply us-
ing the second wire connector
from step 4.
9. Attach the grounding wire to
the cover with the provided
grounding screw. (Figure 4).
10. Reposition the wire access
covers over the wires and con-
nectors and attach to replace
chassis using the screws
removed in step 2.
11. Refer to Front Glass Installa-
tion section, page 15 for nal
installation procedures.
For Bathroom Use
If this unit is installed in a bath-
room it must be protected by a
GFI receptacle or circuit. If recep-
tacle is used it must be readily
accessible.
To prevent electrical shock this
unit is an electrical appliance
that is not watertight and must be
installed as to prevent water from
entering unit. This must be in-
stalled away from showers, tubs,
etc. Never locate replace where
it may fall into a bathtub or other
water container.
Surface Mount Installation
CAUTION: Two people may
be required for various steps
of this procedure.
1. Choose your method of sup-
plying power to the unit:
• Plug in to an existing outlet or
install an outlet nearby.
• Hard wire the replace. Follow
the hard wiring instructions on
page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Ensure that the On/
Off Switch is set to the Off position
(refer to Operation section) and that
the circuit on which the replace is
to be installed has the power cut off
at the service panel until installation
is complete.
2. Determine the mounting
location of the unit so that the
wall mounting bracket can be
installed into 2 wall studs.
!
NOTE: It is recommended that
the mounting bracket be installed
56 in. (142 cm) off of the ground
to maintain an optimized viewing
angle of the ame.