Installation Guide

4
www.dimplex.com
J
K
L
FRAMING DIMENSIONS
Rough-In Framing Dimensions Firebox Dimensions Rough-In Corner Framing
This replace is a zero clearance design, with the exception of the top of the unit, where any insulation and vapor barrier
should be placed a minimum of 2” (5.1 cm) from the unit. No combustibles can be placed on the top surface of the replace.
CAUTION: Ensure installation does not allow replace to be in direct contact with building vapor barrier or insulation and
meets all local building code.
Four mounting anges on the sides of the unit are provided to facilitate installation.
MOUNTING FLANGES
SECTION A: INSTALLATION INFORMATION
Figure 1
Figure 2
Model A B C D E F G H I J K L
BF45DXP
16.0”
(40.5cm)
45.5”
(115.6cm)
33.5”
(85.1cm)
30.1”
(76.5cm)
15.3”
(38.9cm)
42.0”
(106.7cm)
44.7”
(113.5cm)
22.8”
(57.9cm)
32.7”
(83.1cm)
60.0”
(152.4cm)
42.0”
(106.7cm)
42.0”
(106.7cm)
BF39STP/DXP
16.0”
(40.5cm)
39.5”
(100.3cm)
33.5”
(85.1cm)
30.1”
(76.5cm)
15.3”
(38.9cm)
36.0”
(91.4cm)
38.7”
(98.3cm)
22.8”
(57.9cm)
32.7”
(83.1cm)
54.0”
(137.2cm)
38.0”
(96.5cm)
38.0”
(96.5cm)
BF33STP/DXP
15.0”
(38.1cm)
33.5”
(85.1cm)
29.5”
(75.0cm)
25.7”
(65.3cm)
14.3”
(36.3cm)
29.6”
(75.2cm)
32.8”
(83.3cm)
18.8”
(47.8cm)
28.5”
(72.4cm)
48.0”
(121.9cm)
34.0”
(86.4cm)
34.0”
(86.4cm)
Air Intake Slots
There are two mounting anges located on each side of the replace insert.
From the inside of the unit, bend tabs outward and mount to the inside of the framing using suitable hardware.
Mounting
Flanges