Installation guide

BF33STP, BF33DXP, BF39STP, BF39DXP

If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs

and heating elements to cool off to avoid accidental burning of skin.

Disconnect circuit power before attempting any maintenance or cleaning to reduce the

risk of electric shock or damage to persons.

TO REPLACE HEATER ON/OFF SWITCH (without remote control option)

NOTE: Remote control kit does not have individual heater switch. Refer to page 27

for remote control kit replacement instructions.

1. Open the steel curtains (remove glass doors if applicable).

2. Remove the log grate retaining screws and remove the log grate.

3. Pull the rear edge of the log set forward by grasping the ember bed by the sides

(handle the log set only by the ember bed and not the logs) and pulling firmly

until the rear tab pops out from under the back ledge, then lift out.

4. Disconnect the log set LED wire harness from unit. (DX MODELS ONLY)

5. Remove the light bulb closest to the heater on/off switch for easier access.

6. Locate the switch cover plate and remove the mounting screws.

7. Remove the switch cover plate by releasing assembly from the quick connect

connection.

8. Depress the retainer clips on the rear of the switch and push the switch out of the

bottom cover.

9. Disconnect the wiring connections noting their original locations.

10. Properly orientate the new switch and connect all of the wiring connections.

11. Reassemble in the reverse order as above.

NOTE: To replace the log set re-connect the logset LED wire harness to the unit,

insert the front edge, pushing back down until the rear tab snaps under the back

ledge and the logs are resting against the mirror.