Installation Sheet

www.dimplex.com

120V/240V WALL MOUNTED THERMOSTAT

NOTE: Before installing the unit complete the following:

1. Install main power connection with appropriate wiring - directly to the main power or through a wall switch.

2. Install a 2 conductor wire with ground (3 wires total) from the thermostat wall box to the junction box on the unit.

NOTE: Wiring of the thermostat must be completed prior to installing the unit.

NOTE: The following installation instructions are for a single pole thermostat.

1. Loosen the screw securing the junction box and remove the cover.

2. Remove the knockouts (if necessary) or use the provided cable clamp.

3. Pull out the three wires marked 1, 2, and G (red, red, and green).

4. Remove the wire connector and separate the wires marked 1 & 2.

5. Connect the 1 wire (red) from the unit to the Neutral (white) wire from the wall thermostat box by using a wire connector

(not supplied).

6. Connect the other end of the Neutral (white) wire from the thermostat wall box to the red wire from the wall thermostat.

7. Connect the 2 wire (red) from the unit to the black wire from the thermostat wall box by using a wire connector (not sup-

plied).

8. Connect the other end of the black wire from the thermostat wall box to the black wire from the wall thermostat.

9. Connect the Ground wire (green) from the unit to the Ground (green) wire from the thermostat wall box by using a wire

connector (not supplied).

10. Connect the other end of the Ground wire (green) to the thermostat wall box ground screw.

11. Ensure that all connections are tight.

12. Insert all the wiring of the wall mounted thermostat into the wall box.

13. Insert all the wiring back into the unit and secure with a cable clamp.

FIREPLACE JUNCTION BOX

WALL

THERMOSTAT

RED – 1

GROUND - G

RED – 2

BLACK

RED

GROUND

RED

BLACK

BLACK WIRE

WHITE WIRE

GROUND

SCREW

GROUND

NOTE: This only illustrates

thermostat connection, see

previous sections for main

power connection instruc-

tions.