Models 500002388 500002389 500002400 500002401 500002398 500002399 500002410 500002411 RBF30-FG RBF30WC-FG RBF36-FG RBF36WC-FG RBF36P-FG RBF36PWC-FG RBF42-FG RBF42WC-FG Installation and User’s Guide We value your feedback! We value your feedback! Your input helps to create even better products and experiences. Share the warmth and leave a review. dimplex.com/sharethewarmth IMPORTANT SAFETY INFORMATION: Read this manual first before attempting to install or use this electric fireplace.
Table of Contents Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 IMPORTANT INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Electrical Rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Welcome Thank you for purchasing a Revillusion® Built-in Electric Firebox by Dimplex. Please carefully read and save these instructions. WARNING: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Please record your model and serial numbers for future reference. Model and serial numbers can be found on the label located behind the front glass of your fireplace.
IMPORTANT INSTRUCTIONS When using any electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. These precautions include: ① Read all instructions before using the Revillusion® Built-in Electric Firebox. DANGER: High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct the front of the firebox. ② This firebox is hot when in use.
IMPORTANT INSTRUCTIONS WARNING: Remote control contains small batteries. Keep away from children. If swallowed, seek medical attention immediately. Do not install battery backwards, charge, put in fire or mix with used or other battery types may explode or leak causing injury. CAUTION: Always use a qualified technician or service agency to repair the built-in electric firebox.
Technical Specifications Electrical Rating Voltage: 120 V 60 Hz (3-Wire), 208 V 60 Hz (4-Wire), or 240 V 60 Hz (4-Wire) Power: 1300 W at 120 V (10.8 A), 1975 W at 208 V (9.5 A), 2575 W at 240 V (10.
Package Contents Image Description Quantity Firebox 1 Remote control 1 User’s and installation guide 1 Front glass 1 Glass trim 1 Models RBF30 RBF30WC RBF36 RBF36WC RBF36P RBF36PWC RBF42 RBF42WC Owner’s Manual We value your feedback! Your input helps to create even better products and experiences. Share the warmth and leave a review. dimplex.com/sharethewarmth IMPORTANT SAFETY INFORMATION: Read this manual first before attempting to install or use the Revillusion™ Electric Fireplace.
Installation Placement This is a zero clearance design, with the exception of the top of the unit, where any insulation and vapor barrier should be placed a minimum of 2" (5.1 cm) from the firebox. The Revillusion® Built-in Electric Firebox does not require any special venting. Installation in a Bathroom If this unit is installed in a bathroom, it must be protected by a GFCI receptacle or circuit. If a receptacle is used, it must be readily accessible. This electrical appliance is NOT watertight.
Installation Installation Instructions 1. Rough-in the framing opening, following the recommended framing dimensions below. ! NOTE: The materials used for the finished surround must be cut to precise dimensions (dimensions B & C) as the ¼" (0.6 cm) self-trimming flange is only to create a finished appearance.
Installation 2. Remove the screws that secure the electrical cover in the top right corner at the back of the firebox to complete the wiring. Figure 4 3. Complete the wiring according to instructions in the Electrical Installation section (pages 12–13). Reinstall the electrical cover after completing wiring. 4. Place the firebox into the framed opening. Level with shims if necessary. WARNING: The built-in electric firebox must NOT be in direct contact with any building vapor barrier or insulation.
Installation Front Glass Installation 1. Secure the glass pins to the bottom brackets of the glass. (Figure 6, hardware A and B) Hardware 2. Secure the left (L) and right (R) brackets to the top of the fireplace. (Figure 7, hardware C) A x 2 B x 2 C x 2 3. Align the glass pins on the glass to the holes in the opening of the firebox. Tilt the glass upward, and secure it to the brackets. (Figure 8, hardware D) D x 2 4. Place the magnetic glass trim.
Installation Electrical Installation WARNING: The installation of the electric fireplace must comply with the applicable Local and/or National Electrical Codes and utility requirements. Employ qualified personnel where required by law. Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock, or injury to persons.
Installation 120 V Hardwire Installation 240 V Hardwire Installation Use 2-conductor wires with ground (3 wires total) from the power supply (breaker panel) to the junction box on the built-in electric firebox. Use 3-conductor wires with ground (4 wires total) from the power supply (breaker panel) to the junction box on the built-in electric firebox. 1. Pull out the 5 wires marked L1, L2, N, NH, and G (black, red, white, blue, and green). 1.
Installation Plug Kit Installation Heater Hardware Disconnect 120 V Power Cord Installation The fireplace heater can be permanently disabled by removing the electronic jumper on the main control board. WARNING: This heater is not intended for use with an extension cord. Plug the cord directly into an appropriate wall receptacle. 1. In the back right corner of the unit, locate and remove the electrical cover plate, by removing the two securing screws. 2. Pull out the marked wires. 3.
Wiring Diagram M M 15
Operation General Operation WARNING: The Revillusion® Built-in Electric Firebox must be installed properly before it is used. The hidden touch controls are located on the upper center of the fireplace. To operate correctly, the remote control must be pointed toward the hidden touch controls. The remote control has a range of approximately 30 ft (9 m). ! NOTE: The heating element remains hot after shutdown.
Operation Standby Flame Heat Heat Disable Press When the unit is turned back on, it will retain the previously used settings. Press to turn the flame effect on or off. Press to turn the heat on or off. The fireplace can be operated in heat only mode by turning off the flame and color effects. Press and hold and at the same time for 2 seconds to disable or enable the heat function. This action must be performed on the hidden touch controls. When the heat is disabled and either the display.
Operation Timer Press repeatedly until the desired number of hours of the timer is displayed. When this function is active, the fireplace will turn off after a set amount of time. The timer can be set from 30 minutes to 8 hours in intervals of 30 minutes. To turn the timer off, press repeatedly until 0 appears on the display. While the timer is active, press Controls Lock once to see the time remaining. Hold and at the same time for 2 seconds to lock or unlock the hidden touch controls.
Maintenance Remote Control Battery Replacement Figure 18 1. Remove the battery cover screw using a Philips screwdriver. 2. Slide the battery cover open. 3. Install a 3V (CR2032) lithium battery in the battery holder. The positive (+) side of the battery faces up. 4. Close the battery cover and secure with the screw. The battery must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling advice in your area.
Troubleshooting For more troubleshooting, consult the Revillusion Service Manual which can be found at www.dimplex.com/product-downloads Problem Display Cause Fireplace does not turn on with the manual touch controls N/A No incoming power Fireplace does not turn on with the remote control N/A The batteries in the remote control are dead or installed incorrectly Circuit breaker trips or fuse blows when unit is turned on Fireplace does not respond to commands on the hidden touch controls.
Warranty Two Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex Revillusion® Built-in Electric Firebox Models: 500002388, 500002389, 500002400, 500002401, 500002398, 500002399, 500002410 and 500002411.
Warranty access to all serviceable parts of the product. • For products (other than surrounds (mantels) and trims) for the period commencing at 12:01 a.m. on the day after the first anniversary of the first purchase and ending at midnight on the second anniversary of the date of first purchase, this limited warranty entitles the purchaser to replacement parts only without charge.
We value your feedback! Your input helps to create even better products and experiences. Share the warmth and leave a review. dimplex.com/sharethewarmth 1-888-346-7539 | www.dimplex.com In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.