Project Ideas

STEP 3
Use your measuring tape to mark the center of the dowel holes as
shown below,. Pay special attention to accuracy so they end up as
evenly spaced as possible.
Center your mirror in the empty area to the left, about 1” from the left
edge and 2” from the bottom. Mark its four corners with a pencil.
STEP 4
Use your power drill with a 3/4” router bit to drill through the center of
your 16 dowel holes.
STEP 5
Sand the edges of the project panel and the inside of each dowel
hole until smooth.
STEP 6
Apply the mirror adhesive to the back of the mirror and press onto the
pegboard at your corner marks.
Note: This is the best
time to paint or stain
your project if desired.
Just make sure you let
each step dry thoroughly
before moving on to
the next.
page 2 of 3
OPTIONAL
If you’d like your pegboard to stand
out ¾” from the wall, use your skill
saw to cut your extra 4” x 8” piece
of panel widthwise into four small
blocks of equal size (2” x 4” each).
Turn your pegboard facedown and
use your wood glue to secure a
block in each corner.