User Manual

39
Configuring the Stomp Loop
1. If the Pedalboard window is not already acve, select
it by touching the Pedalboard icon.
2. Touch the Edit buon to display the Edit screen.
3. Touch the
icon located in the empty pedal slot.
4. Select the OTHER category.
5. Select Stomp Loop.
6. Touch the Done buon.
7. To posion where the Stomp Loop is located in the
signal path, touch the Stomp Loop icon and drag it to
the desired posion.
8. Once complete, touch the Performance buon to get
back to Performance mode.
9. Press the STOMP LOOP footswitch to engage and
disengage the Stomp Loop. When this footswitch’s LED
is on, the Stomp Loop is enabled and the connected
device is inserted into the iPB-10 signal path.
NOTE: If enabled, the Stomp Loop connecon remains acve when a tone is bypassed.
9.
Assigning FootswitchesAssigning Footswitches
1.
2.
8.
7.
4.
5.
3.
6.