Technical data

10.22 Cassette Paper Feeder Board
4. Lift the mounting bracket and unplug the 7-pin connector from J902 on the
paper feeder board.
Caution: When you replace the mounting bracket, make sure the tab on
the bracket engages the slot on the bottom of the bulkhead. If the bracket is
incorrectly mounted, the feeder size-sensing switches may work incorrectly
or can produce intermittent errors.
5. Remove the bracket assembly and place on a work surface.
6. Remove the four screws that hold the paper feeder board to the mounting
bracket.
7. Remove the paper feeder board.
006104s
Removal and Replacement Procedures and RSL 10–69