User's Manual

DA16200 AT GUI Tool
User Manual
Revision 1.0 DRAFT
03-Jul-2019
CFR0012
6 of 20
© 2020 Dialog Semiconductor
2.2 Setup Serial Terminal Utility
Users can control DA16200 by using a serial terminal tool (e.g. Teraterm or SecureCRT) and the
following configurations are required to connect to the console of DA16200.
● Port: Com port number on Windows system
● Baud rate: 115,200 bps
● Data bits: 8 bits
● Parity: None
● Stop bits: 1 bit
● Flow control: None
Figure 1: Terminal Configuration
When the DA16200 board is connected, two COM ports will be detected on the Window machine.
One (UART0) is for console command and the other (UART1) is for AT command. Normally, the
large number COM port is for the AT commands and higher number COM port is for the console.