Use & Care Guide

14
English
ELECTRICAL Refer to all safety instructions before using unit. Observe extension cord safety instructions if necessary. Always move the On/Off switch (A) to the OFF
position before removing the plug from the
outlet. TRANSPORTING When transporting the compressor in a vehicle, trailer, etc. ensure that the air tank is drained and the unit is secured and placed on a flat horizontal surface. NOTE: Use
V
U
recommended tie down points (U) when transporting. Use care when driving so to avoid tipping the unit over in the vehicle. Damage can occur to the unit or surrounding items if unit is tipped. LIFTING Always use two people when lifting and lift from the recommended lift points (V). MOVING 1. Grasp handle (O) of compressor and pull up until it stops. Turn
knobs to lock handle in place.
2. Grasp handle and tilt compressor so unit can be rolled on the
tires.
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or cause loss of balance.
3. When location is reached slowly lower compressor to ground.
Always store compressor in a horizontal position.
NOTE:
Should the unit tip over, hard starting and smoking will occur
due to oil spillage.
DOLLY FEATURE 1. Grasp handle (O) of compressor and pull up until it stops. Turn
knobs to lock handle in place. IMPORTANT: Always pull handle
up and lock in place before using as a dolly.
2. Place cargo onto top panel of compressor. 3. Secure cargo to top panel with retention straps.
Hook cargo retention straps into positioning holes in top panel. NOTE: Retention straps to secure cargo may be purchase from a local hardware store or home center in a variety of sizes.
CAUTION: Risk of unsafe operation. Do not transport unsecured cargo. CAUTION: Risk of unsafe operation. Load limit is 100 lbs. do not
exceed.
4. With cargo secured, grasp handle and tilt
compressor so unit can be rolled on the tires.
WARNING: Risk of unsafe operation. Ensure
proper footing and use caution when rolling compressor so that unit does not tip or cause loss of balance.
5. When location is reached slowly lower com
-
pressor to ground. Always store compressor in a horizontal position.
PREPARATION FOR USE Pre-Start Checklist (Fig. 1) 1.
Ensure the On/Off switch (A) is in the OFF position.
2.
Plug the power cord into the correct branch circuit receptacle.
See Voltage and Circuit Protection under Installation.