Operation Manual

26
ENGLISH
• Release the spindle lock.
• To remove the disc, loosen the flange (14) with
the two-pin spanner.
Do not use a damaged disc.
Fitting a wire cup brush
• Screw the wire cup brush directly onto the
spindle without the use of the spacer and
threaded flange.
Mounting the side handle (fig. D1 & D2)
• For grinding, screw the side handle (5) tightly into
one of the holes (15) on either side of the gear
case (fig. D1).
• For cutting, screw the side handle (5) tightly into
the top hole (16) or into one of the holes (17) on
either side of the gear case (fig. D2).
D28423/D28432C - Rotating the main handle
(fig. E1 & E2)
The rotary handle facilitates a more comfortable
handling in cutting applications with the side handle
mounted in the top hole.
The rotary handle has locations at 30°, 60° and 90°
both left and right.
• Pull the spring-loaded tab (18) to unlock the
rotary mechanism (fig. E1). Hold the tab in the
pulled-out position.
• Rotate the handle (19) into the desired position
(fig. E2).
• Release the tab and lock it in position.
• Check that the rotary mechanism is locked.
Do not use the tool unless the rotary
handle is in the locked postion.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the direction
of the arrows on the accessory and the tool.
Switching on and off (fig. A)
The on/off switch is equipped with an unlocking
switch or a locking switch for continuous operation.
On/off switch (1) with locking switch (2)
• To run the tool, depress the locking switch (2)
and subsequently operate the on/off switch (1).
• Release the locking switch (2).
• To stop the tool, press the on/off switch again.
On/off switch (1) with unlocking switch (2)
(France only)
• To run the tool, depress the unlocking switch (2)
and subsequently operate the on/off switch (1).
• Release the unlocking switch (2).
• To stop the tool, release the switch.
Do not switch the tool on or off when
under load.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your DEWALT Power Tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.